AMX Modero MVP-5200i Operation/Reference Manual page 25

FIG. 13 Installation of MVP-WCS-52
For ease of installation, put each screw on a neodymium magnet in the device's
interior compartment to keep them on hand until they are needed.
11. After fully seating the screws, wipe down the area around the screw holes with the alcohol prep pad
from the Installation Kit. Take a rubber foot and remove its adhesive backing. Put the foot, adhesive-
side down, in the slot surrounding the screw hole in the Wall Charging Station. Press down firmly to
remove any air bubbles from underneath the foot.
12. Install an MVP-5200i device by placing it into the interior compartment bottom-first. Press the top
of the touch panel until it is flush with the Wall Charging Station. The neodymium magnets will
hold it in place.
13. To remove the MVP-5200i, unlock the touch panel (see the Unlocking the touch panel section on
page 13 for more information) and wait for the touch panel to pull away from the Wall Charging
Station. Once it has been released, grip it by the top of the device, and pull it free from the Charging
Station.
MVP-5200i Modero Viewpoint Widescreen Touch Panel
Screw holes
Accessories
Plastic back box
Neodymium magnets
MVP-WCS-52
Rubber feet
17