Intercom Microphone; Stylus - AMX Modero MVP-5200i Operation/Reference Manual

Navigation Wheel behavior in each Power Mode (Cont.)
Power Mode
Stand By
(Display Off,
Electronics
halted)
Stand By
(Display Off,
Electronics
halted)
Stand By
(Display Off,
Electronics
halted)
Shut Down (Off)
Shut Down (Off)
Shut Down (Off)
The navigation wheel may also be programmed to initiate specific commands. For more information,
please see the Programming section on page 107.
Turning on the MVP-5200i
The MVP-5200i uses one of two methods to turn it on. These use either the navigation wheel or the
touchscreen. To learn which method works for your panel:
1.
Press any of the navigation wheel's compass points and hold until the AMX splash screen appears
on the touchscreen.
2. If the navigation wheel does not respond, press the touchscreen and hold until the AMX splash
screen appears on the touchscreen.

Intercom Microphone

The MVP-5200i contains a built-in microphone above the upper lefthand corner of the touch screen for
video and audio conferencing capabilities. This microphone is concealed by the casing.

Stylus

The MVP-5200i comes with a unique touchscreen stylus that slides into a storage groove on the right
side of the device when not in use. Replacement styluses may be ordered in a 3-pack (FG5966-30-xx)
from www.amx.com.
MVP-5200i Modero Viewpoint Widescreen Touch Panel
Power Enters Mode By - Exits Mode By -
Status
Battery Enabled Advanced
Power Power Management
1. Display TimeOut
setting reached
2. Sleep Send
Command
External N/A
Power
Charging N/A
Battery 1. Panel Shutdown
Power setting reached
2. Panel Shutdown
button pressed
3. Navigation Wheel
button held
External N/A
Power
Charging N/A
LED Behavior
(Sleep Blink
Setting)
Enabled Disabled
1. Apply External Off
Power
2. Touch Display
3. WakeUp Send
Command
Same as Sleep OFF
Mode
Same as Sleep OFF
Mode
1. Apply External OFF
Power
2. Press and hold
Navigation Wheel
button
Same as Sleep OFF
Mode
Same as Sleep OFF
Mode
Introduction
Notes
OFF External
Power will
transition
unit to
Sleep Mode
in < 10
seconds.
OFF
OFF
OFF External
Power will
transition
unit to
Awake
Mode after
boot up
OFF
OFF
7