AMX Modero MVP-5200i Operation/Reference Manual page 14

Introduction
The light at the center of the navigation wheel brightens and dims based on its source of power. It lights
at full intensity when attached to a power source, such as the Table Charging Station (see the Table
Charging Station section on page 9) or the Wall Charging Station (see the Wall Charging Station section
on page 11), but lights at only half intensity when running on its internal battery. This allows the user to
ascertain whether the device was properly installed in a charging station, as the brightness will visibly
increase with a correct docking and will flash while charging. (The flashing during recharging may be
disabled via the device's on-board Setup page, as explained in the Setup Pages section on page 49.) The
behavior of the navigation wheel LED is dependent upon its status, and whether the blink function for
the LED while in sleep mode is enabled:
Navigation Wheel behavior in each Power Mode
Power Mode
Awake (Full On)
Awake (Full On)
Awake (Full On)
Sleep (Display
Off)
Sleep (Display
Off)
Sleep (Display
Off)
6
Power Enters Mode By - Exits Mode By -
Status
Battery N/A
Power
External N/A
Power
Charging N/A
Battery 1. Display TimeOut
Power setting reached
2. Sleep Send
Command
External 1. Display TimeOut
Power setting reached
2. Sleep Send
Command
Charging 1. Display TimeOut
setting reached
2. Sleep Send
Command
LED Behavior
(Sleep Blink
Setting)
Enabled Disabled
N/A ON
N/A ON
N/A BLINK
1.Touch display OFF
2. Press
Navigation Wheel
3. Press
Navigation Wheel
center
4. Apply External
Power
5. WakeUp Send
Command
1. Touch display OFF
2. Press
Navigation Wheel
3. Press
Navigation Wheel
center
4. Apply External
Power
5. WakeUp Send
Command
1. Touch Display BLINK
2. Press
Navigation Wheel
3. Press
Navigation Wheel
center
4. Apply External
Power
5. WakeUp Send
Command
MVP-5200i Modero Viewpoint Widescreen Touch Panel
Notes
ON
ON
BLINK
OFF External
Power will
transition
device to
Display On
Mode.
OFF
OFF