Automation Editing Between Strips/Projects - Merging Pyramix User Manual

Automation Editing Between Strips/Projects

Automation data can be cut/copy/past ed between mixer strips with differing pan types and between projects. I.e.
a Pan automation Track can be copied to a stereo Track having a Balance control. This is only possible in the fol-
lowing cases :
• Pan
• Balance
• LeftRight mono surround panner ->
• LeftRight mono surround panner ->
• Pan
• Balance
Note: Only the left side of a Stereo strip's Surround Panner is reassigned to/from a Pan/Balance .
Automation Buses Reassignment Dialog
When Automation > Bus Reassignment on Paste is set on the following dialog will appear if some automated
bus elements of a strip are available in the automation clipboard.
When Automation > Bus Reassignment on Paste is set off following dialog will appear only when at least one
bus in the clipboard is not available in the target mixer.
The Bus Reassignment dialog left-hand pane shows the Buses automation data on the Clipboard currently.
The Bus Reassignment dialog right-hand pane shows the Destination Buses available in the current Project's
Mixer.
By default, the Automation > Bus Reassignment dialog assigns buses together which match by Bus type in the
left and right panes.
In the screenshot, Surround Bus 1 is assigned to Surround Bus 1 , Stereo Bus 1 is assigned to Stereo Bus 1 etc.
This dialog enables you to:
• Copy an automation Track to or from different or similar Bus types of a strip. When bus types are, for exam-
ple: SR1 to ST1 .
• Copy an automation Track to or from different types of strip (mono, ms, stereo and GPS).
-> Balance
-> Pan
Pan
Balance
-> LeftRight mono surround panner
-> LeftRight mono surround panner
Automation Buses Reassignment dialog
Automation : Automation Editing 15 - 384