Merging Pyramix User Manual page 270

usual way. Click on any complete bus or any available stem or any bus/stem channel to select it for monitoring.
Selection is exclusive unless the Ctrl key held is down. Then selection is cumulative and clicking adds or subtracts
Sources according to their current state.
Buses / Externals button
Note: At bottom left in the screenshot above the button labelled Buses indicates which sources
are available for activation. Clicking on this button toggles through Buses, Externals and Buses
/ Externals.
Note: Multiple selections are made by holding the Ctrl key and clicking.
Main, centre section:
Selected Sources
<< SR1 >> : Select previous/next Pyramix source. Only sources visible in the Sources section are available. I.e.
If the component channels of a bus or stem are collapsed this bus or stem is switched as a unit when the compo-
nent channels are visible in the Sources section then clicking on the << or >> buttons steps through each avail-
able channel in turn.
<< DA-88 >> : Select previous/next External Source. Only External Sources visible in the Sources section are
available.
Note: Clicking on any of the << or >> buttons cancels the selection made previously in the
Sources section.
Selected Output
<< Surround 5.1 >> : Select previous/next Speaker Set .
<< Main >> : Select the previous/next Downmix defined in the Configure page.
Main area
Speakers are inactive (grayed) if they are not connected in the Configure page.
The Mode buttons at the bottom determine the function of the active Speaker buttons.
Mute : Clicking on a speaker mutes it. Selections are cumulative.
Solo : Clicking on a speaker solos it. Selections are cumulative.
SoloX : Solo eXclusive on the clicked speaker. Selections toggle.
Phase : Clicking on a speaker reverses its phase. Selections are cumulative. Useful for quick imaging checks.
In Place Works in conjunction with Solo and SoloX . Toggles between In Place and Center .
Reset : Deselect all speakers.
In Place/Center : In Solo and SoloX , toggles between In Place and Center . Center routes the soloed channel(s) to
the Center speaker or equally to the L/R speakers if no center speaker is present. In Place mode is the normal Solo,
SoloX mode.
Output, right-hand area
Monitor Level box Displays the current output level. Output level can be entered numerically in the box after
clicking on it.
Volume Knob: sets all the output gains in a range from -144.5dB to +24dB. Double-click to set it to 0dB.
Note: Maximum permissible volume can be set in the Configure page.
Mute: button mute the outputs.
Dim: button reduces the output level by an amount set in the Configure page. Default value is -20dB.
Monitor : Monitor ! page 11 - 270