Setting The Auto Continue Recovery Time - Kyocera FS-6020 Operation Manual

Setting the Auto Continue Recovery Time

Follow the procedure given below to change the recovery
time for Auto Continue.
Press the MENU key.
1
Press the or
2
pears.
Others
Press the key.
3
Press the or
4
Continue Mode > appears.
>Auto Continue >
Mode On
Press the key and display >>Auto Continue
5
Timer.
Press the ENTER key. A blinking cursor (_) appears.
6
>>Auto Continue
Timer 030Sec.
Press the or
7
ue of the figure where the cursor is blinking and set
the desired time. The time must be set between 000
and 495 seconds, in 5-second increments. If set to
000, printing will be continued immediately without
allowing any time interval. You can use the
keys to move the cursor right and left.
Display the desired time and press the ENTER key.
8
Press the MENU key. The message display returns to
9
Ready.
key repeatedly until Others > ap-
>
key repeatedly until >Auto
key to increase or decrease the val-
and
Chapter 1 Using the Operator Panel
1-57