Selecting The Paper Size Unit For The Paper Cassette; Entering The Width And Length - Kyocera FS-6020 Operation Manual

Chapter 1 Using the Operator Panel
>Cassette Size >
Custom
Selecting the Paper Size Unit for the Paper
Cassette
Set the paper size unit as described below when Custom is se-
lected.
When the paper size is set to Custom, press the
1
key.
>>Unit appears and the unit currently set is dis-
2
played. You can select either mm or inch. The default
setting is mm.
>>Unit
mm
Press the ENTER key. A blinking question mark (?)
3
appears.
>>Unit
? mm
Press the or
4
Press the ENTER key.
5

Entering the Width and Length

Then, use the following procedure to set the paper size when
the paper size is set to Custom.
1-16
key to select mm or inch.
When the unit of measurement is set, press the
1
key. >>X Dimension appears (the paper width set-
ting).
>>X Dimension
297 mm
Press the ENTER key. A blinking cursor (_) appears.
2
>>X Dimension
297 mm
Press the or key to increase or decrease the
3
value of the figure where the cursor is blinking and
display the desired width. The width can be set be-
tween 148 and 297 mm (5.83 to 11.69 inches). You
can use the and
and left.
Display the paper width and press the ENTER key.
4
When the width is set, press the
5
sion appears (the paper length setting).
>>Y Dimension
432 mm
Press the ENTER key. A blinking cursor (_) appears.
6
>>Y Dimension
432 mm
Set the desired length in the same way as you set
7
the paper width. The length can be set between 210
and 432 mm (8.27 to 17.01 inches).
>>Y Dimension
432 mm
When the desired paper length is displayed, press
8
the ENTER key.
Press the MENU key. The message display returns to
9
Ready.
keys to move the cursor right
key. >>Y Dimen-