Deleting A Private/Stored Job; Printing A Code Job - Kyocera FS-6020 Operation Manual

Chapter 1 Using the Operator Panel
>Private/Stored
?Harold
Press the or
6
name (Arlen, in this example).
>Private/Stored
?Arlen
Press the ENTER key. The user name and the job
7
name (Agenda, in this example) entered in the
printer driver appear with a blinking question mark
(?).
>Arlen
?Agenda
Press the or
8
Press the ENTER key. The ID input line appears.
9
Enter the four-digit access code entered in the print-
er driver and press the ENTER key. To enter the ID,
press the or
ber to be changed and then enter the correct number
by pressing the
In printing a stored job, the access code must be en-
tered in this step only when it has been set on the
printer driver.
>Agenda
ID
You can set the number of copies to be printed. To in-
10
crease the copy count, press the
the copy count, press the
>Agenda
Copies
Press the ENTER key to finalize the copy count. The
11
printer prints the specified number of copies for the
job.

Deleting a Private/Stored Job

Follow steps 1 through 8 in the above section.
1
When the title of the job to be printed is displayed
2
(Agenda, in this example), press the ENTER key. En-
ter the four-digit access code entered in the printer
driver and press the ENTER key.
1-38
key to display the desired user
key to display the desired job title.
key to move the cursor to the num-
or key.
0000
key; to decrease
key.
001
>Agenda
Copies
Press the key repeatedly until Delete appears
3
for the number of copies.
>Agenda
Delete
Press the ENTER key. The private/stored job is delet-
4
ed from the hard disk.

Printing a Code Job

KM-NET Job Manager
Install the KM-NET Job Manager software from the
Mita Digital Library
CD-ROM supplied with the printer. To
do this, from the CD-ROM Main Menu, select Printer Utilities
> Install KM-NET Job Manager.
Browse through Windows Start > Programs >
1
KYOCERA MITA > KM-Net > Job Manager.
Click the Add printer icon (below). Select the Local
2
or Network port.
NOTE
If you use the local parallel port to connect to the printer,
make sure that the printer driver is set to print to a local
port. To check this out, click the Details tab of the printer
Properties, and note the Print to the following port set-
ting.
Add printer
icon
Follow the wizard until the Select printer dialog box
3
is reached. When the printer is found in the Printer
List, click (highlight) it, then Finish.
001
Kyocera