Kyocera FS-6020 Operation Manual page 84

Message
Memory overflow
Press GO
MemoryCard err##
Press GO
Print overrun
Press GO
RAM disk error ##
Press GO
Virtual mailbox
full
Warning
image adapt
Warning
Low memory
:Alarm buzzer sounds when an error occurs. Press the CANCEL key to stop the alarm buzzer.
The total amount of data received by the printer exceeds the printer's internal memory.
Check the memory on the status page and delete unnecessary macros and external fonts or
expand printer memory. See
the GO key to resume printing. You can abandon printing by the CANCEL key.
If Auto Continue is set to On, printing will be automatically resumed after a preset period of time.
Setting the Auto Continue on page 1-56
See
This message appears when an error occurs during access to the memory card using the
PRESCRIBE RWER command or from the printer's operator panel.
Look at the error code given in place of ## and see the corresponding description given below.
01: The memory card does not meet specifications. This memory card cannot be used by this
printer. Insert a memory card which can be used by this printer.
02: The memory card is not installed. Recheck the requirements for using the memory card.
04: The capacity of the memory card is insufficient. Clean up files.
05: Specified file not on memory card.
06: No memory for use by memory card. Expand printer memory.
The data transferred to the printer was too complex to print on a page.
Press the GO key to resume printing. (The page may break in some pages.)
You can abandon printing by the CANCEL key.
Check the memory on the status page and delete unnecessary macros and external fonts or
expand printer memory. See
Note: After this message is displayed, page protect mode will be On. To maintain optimum use
of memory during printing, display >Page Protect from the operator panel, and re-
select Auto. See Setting the Page Protect Mode on page
If Auto Continue is set to On, printing will be automatically resumed after a preset period of time.
Setting the Auto Continue on page 1-56
See
Look at the error code given in place of ## and see the corresponding description given below.
01: Format error. Try turning the power off and on again.
02: RAM disk mode is Off. Turn RAM disk mode On. See
50
for details.
04: No disk space. Clean up files.
05: Specified file is not on disk.
06: No memory for use by disk system. Expand printer memory.
The storage area for the VMB is full.
Print out accumulated VMB data.
Printing job cannot be done in current resolution because there is not enough internal
memory.
Try adding more memory or changing resolution. See
expansion memory.
The printer's internal memory is running low due to the number of fonts and macros downloaded.
Print a status page to see how much user memory is left, and try deleting unnecessary fonts and
macros or adding more memory. See
Corrective Action
Chapter 6 Option Units
for details about expansion memory. Press
.
Chapter 6 Option Units
for details about expansion memory.
.
Chapter 6 Option Units
Chapter 6 Option Units
Chapter 4 Troubleshooting
1-51.
Setting the RAM Disk Size on page 1-
for details about
for details about expansion memory.
4-7