Setting The Number Of Copies; Selecting The Reduced Print - Kyocera FS-6020 Operation Manual

Chapter 1 Using the Operator Panel

Setting the Number of Copies

You can set the number of copies to be printed of each page for
the current interface. This value can be set between 1 and
999. It can be set whenever the message display indicates
Ready.
Press the MENU key.
1
Press the or
2
appears.
Page Set
Press the key.
3
Press the or
4
pears.
>Copies
Press the ENTER key. A blinking cursor ( _ ) ap-
5
pears.
>Copies
Press the or
6
ue of the figure where the cursor is blinking. It can
be set between 1 and 999. You can use the
keys to move the cursor right and left.
When the desired value is displayed, press the
7
ENTER key.
Press the MENU key. The message display returns to
8
Ready.
1-30
key repeatedly until Page Set >
>
key repeatedly until >Copies ap-
001
001
key to increase or decrease the val-

Selecting the Reduced Print

You can print with the reduced size. This menu is used to set
the source paper size and the paper size to use after reduc-
tion.
NOTE
• Printed results when making reductions differ from equivalent
size printing. Sometimes the line width of characters may not
be consistent or lines may appear in figures or image
patterns. Also, thin lines may not be reproduced on the
reduced print.
• In the reduction mode, printed barcodes may not be read.
Bring up the Zoom menu. The following display will appear.
>Zoom
Source size indicator...This is the paper size before reduc-
tion.
This must be the same as the paper size set for print data
from the computer.
Target size indicator...This is the paper size after reduction.
This must be the same as the paper size set for the paper cas-
sette.
and
[CS]→[CS]
Target size indicator
Source size indicator