Kyocera FS-6020 Operation Manual page 82

Message
Check
process unit
Close duplexer
rear cover
Close
top cover
Close rear
cover
Face-down tray
paper full
Load Cassette 1(to 5)
(paper size)/(paper type)*
*(paper size) and (paper
type) are displayed flashing
alternately.
Load MP tray
(paper size)/(paper type)*
*(paper size) and (paper
type) are displayed flashing
alternately.
Missing
duplexer
Option interface
Error ##
Paper jam
###############
Paper path error
Replace toner
TK-400
Toner low
TK-400
: Alarm buzzer sounds when an error occurs. Press the CANCEL key to stop the alarm buzzer.
The process unit or toner container is not installed correctly.
Reinstall either of them correctly. See
The printer does not operate when this message is displayed.
The rear cover of the option duplexer is open.
Close the rear cover.
The top or front cover of the printer is open.
Close the printer top or front cover.
The rear cover of the printer is open.
Close the printer rear cover.
The face-down tray has become full (approx. 250 pages).
You must remove all printed pages from the face-down tray. When the printer senses that the face-
down tray is empty again, it will continue printing into the face-down tray.
There is data for printing that matches with a paper cassette setting (paper size, paper type),
but there is no paper in the paper cassette.
Set paper into the paper source as displayed on the operator panel, and press the GO key to restart
printing. However, the paper cassette numbers (2 to 5) are only displayed when there is an
option paper feeder installed.
Or, if you want to print from a different paper source, press the
alternative? and you can change the source for paper feeding.
After selecting a paper source and pressing the MENU key, Paper Handling > appears. By
pressing the key, the paper type settings menu appears. After setting the correct paper type,
press the ENTER key and printing starts.
There is no paper cassette set (paper size, paper type) that matches with the data for printing,
so printing is done from the MP tray.
Set paper into the MP tray that matches the paper size and type shown on the display and press
the GO key to restart printing.
Or, if you want to print from a different paper source, press the
alternative? and you can change the source for paper feeding.
After selecting a paper source and pressing the MENU key, Paper Handling > appears. By
pressing the key, the paper type settings menu appears. After setting the correct paper type,
press the ENTER key and printing starts.
The option duplexer is not Installed.
The option duplexer installed has been removed or installed incorrectly.
Re-install the duplexer correctly.
A failure has occurred with the option network interface card.
Check the option network interface card installed in the printer.
A paper jam has occurred.
Open the printer's cover(s) or the paper cassette(s) and correct the paper jam (or paper mis-
feeding in the paper cassette). The location of the paper jam is also indicated in place of the #'s.
Online help messages which are useful for correcting the paper jam will be displayed by pressing
Correcting a Paper Jam on page 4-8
the key. (See
?
Any of the paper cassettes installed above the specified paper source is open.
Close the paper cassette.
The printer has stopped due to lack of toner.
Replace the toner container using a new toner kit. The printer does not operate when this
message is displayed. See
Toner is running low.
Replace the toner container using a new toner kit and upon completion of replacement, clean the
internal parts of the printer. See
Corrective Action
Toner Container Replacement on page 3-1
Toner Container Replacement on page 3-1
Toner Container Replacement on page 3-1
Chapter 4 Troubleshooting
or key to display Use
or key to display Use
.)
.
.
(Continued on next page)
.
4-5