Resetting The Toner Counter; Selecting The Message Language; Setting The Automatic Form Feed Timeout - Kyocera FS-6020 Operation Manual

Resetting the Toner Counter

If the toner container was replaced when Replace toner
TK-400 was not displayed, reset the toner counter as follows
so that an accurate toner gauge measurement is indicated on
the status page. Note that if this operation is performed
when the toner container is not replaced, the toner gauge
measurement will not be indicated correctly.
Installation Guide
Also see the
when replacing the toner container.
Press the MENU key.
1
Press the or
2
Counters > appears.
Life Counters >
Press the key.
3
Press the or
4
Installed appears.
>New Toner
Installed
Press the ENTER key. A question mark (?) appears.
5
>New Toner
Installed ?
Press the ENTER key. The toner counter is reset.
6
Press the MENU key. The message display returns to
7
Ready.

Selecting the Message Language

You can select the language of the messages on the message
display by following the procedure given below.
Press the MENU key.
1
Press the or
2
pears.
Others
Press the key.
3
supplied with the toner kit
key repeatedly until Life
key repeatedly until >New Toner
key repeatedly until Others > ap-
>
Chapter 1 Using the Operator Panel
Press the or
4
Language appears. The default message language is
English.
>MSG Language
English
To change the language, press the ENTER key. A
5
blinking question mark (?) appears.
>MSG Language
? English
Press the key. The display cycles through the
6
available selections in the following order (the
cycles in the reverse order):
English
Francais
Deutsch
Italiano
Nederlands
Espanol
Portugues
Press the ENTER key.
7
Press the MENU key. The message display returns to
8
Ready.

Setting the Automatic Form Feed Timeout

When the printer receives no data for a certain time, it times
out and releases the current interface: it prints whatever
data it has in its buffer and feeds out the page. You can ad-
just the time-out time as follows:
Press the MENU key.
1
Press the or
2
pears.
Others
Press the key.
3
Press the or
4
Time Out appears. The default setting is 0 seconds.
>Form Feed
Time Out 000sec.
key repeatedly until >MSG
key repeatedly until Others > ap-
>
key repeatedly until >Form Feed
key
1-53