Enable Interface; Exit-Address-Family; Flash-Update-Threshold - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv4 Routing Volume I)
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Example
Related
Commands
Purpose
10 Confidential and Proprietary Information of ZTE CORPORATION
This example describes how to configure the route priority of the
IS-IS.
ZXR10(config)#router isis
ZXR10(config-router)#distance 120

enable interface

Use this command to start the RIP protocol on an interface.
Router configuration and address family configuration
enable interface <ip-address>
<ip-address>
This command is enabled by default.
This command does not change the configuration parameter data-
base.
This example describes how to start the RIP protocol on the inter-
face 10.20.1.20.
ZXR10(config)#router rip
ZXR10(config-router)#enable interface 10.20.1.20
disable interface

exit-address-family

Use this command to exit RIP VRF address mode configuration.
Router address

exit-address-family

This example describes how to start the RIP protocol on the inter-
face 10.20.1.20.
ZXR10(config)#router rip
ZXR10(config-router)#address-family ipv4 vrf vpn1
ZXR10(config-router-af)#exit-address-family
ZXR10(config-router)#
address-family ipv4 vrf

flash-update-threshold

Use this command to define the RIP flash timer. Restore default
with the no command.
IP address of the specified RIP interface, in
the dotted decimal notation.