Qos-Map Enable; Queue-List Default - Zte ZXR10 Command Manual

Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Interface configuration
qos-map {inherit exp-ipp | trust {ipp | exp}}
no qos-map {inherit | trust}
inherit exp-ipp
trust {ipp | exp}
� Configure MPLS-EXP and IP precedence to inherit each other
with uniform mode, otherwise with pipe or short pipe mode.
� Configure MPLS-EXP to use pipe mode and configure IP prece-
dence to use short pipe mode.
�
ZXR10 T64E/T128 supports this command.
This example describes how to set interface as uniform mode.
ZXR10(config)#interface fei_4/1
ZXR10(config-if)#qos-map inherit exp-ipp
show running config

qos-map enable

Use this command to enable or disable QoS mapping. Delete this
configuration with the disable command.
Interface configuration
qos-map {enable | disable}
Disable
This command is applied to ZXR10 GER.
This example describes how to enable QoS mapping on the inter-
face.
ZXR10(config)#interface fei_4/1
ZXR10(config-if)#qos-map enable
show running config

queue-list default

Use this command to specify a user-defined queue for the packet
which does not match any rules in the customized list. Restore
default with the no form of this command.
Global configuration
queue-list <list-number> default <queue-number>
no queue-list <list-number> default
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 QoS configuration(Router Series)
MPLS-EXP and IP precedence inherit each
other.
Uses MPLS-EXP or IP precedence
63