CyberData VoIP V2 Operation Manual page 32

2. On the Nightringer Configuration page, enter values for the parameters indicated
in
Web Page Item
Enable Nightringer
Nightringer Settings
SIP Server
Remote SIP Port
Local SIP Port
User ID
Authenticate ID
Authenticate Password
Re-registration Interval (in seconds)
Relay Rings to Multicast
Multicast Address
Multicast Port
3. After changing the parameters, click on the Save button.
4. Click Reboot for the new settings to take effect.
CyberData Corporation
Table 2-9.
Table 2-9. Nightringer Configuration Parameters
Description
When the nightringer is enabled, the unit will attempt to
register a second extension with the SIP server. Any calls
made to this extension will play a ringtone.
Type the SIP server represented as either a numeric IP
address in dotted decimal notation.
Type the Remote SIP Port number (default 5060)
(8 character limit).
Type the Local SIP Port number (default 5061)
(8 character limit).
Note: This value cannot be the same as the
found on the SIP Configuration
Type the User ID (up to 64 alphanumeric characters).
Type the Authenticate ID (up to 64 alphanumeric
characters).
Type the Authenticate Password (up to 64 alphanumeric
characters).
Type the SIP Registration lease time in seconds (default is
60 minutes) (8 character limit). Re-registration Interval (in
seconds)
When selected, a user-defined audio file is sent to the
specified multicast address and port when the night ringer is
activated.
Type the Multicast address.
Type the Multicast port number.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
930367H
Setting Up the V2 Paging Server
Configuring the V2 Paging Server
Local SIP Port
Page.
Operations Guide
24