Configuring The V2 Paging Server; Gather The Required Configuration Information; Static Or Dhcp Addressing; Username And Password For Configuration Gui - CyberData VoIP V2 Operation Manual

2.4 Configuring the V2 Paging Server

Use this section to configure the VoIP paging server.

2.4.1 Gather the Required Configuration Information

Have the following information available before you configure the V2 Paging Server.

2.4.1.1 Static or DHCP Addressing?

Know whether your system uses static or dynamic (DHCP) IP addressing. If it uses static
addressing, you also need to know the values to assign to the following V2 Paging Server
parameters:
• IP Address
• Subnet Mask
• Default Gateway

2.4.1.2 Username and Password for Configuration GUI

Determine the Username and Password that will replace the defaults after you initially log in to the
configuration GUI.
• The Username is case-sensitive, and must be from four to 25 alphanumeric characters long.
• The Password is case-sensitive, and must be from four to 20 alphanumeric characters long.

2.4.1.3 SIP Settings

To configure the SIP parameters, determine whether you want to register with the server. If you do,
determine the number of minutes the registration lease remains valid, and whether you want to
automatically unregister when you reboot. To configure the SIP parameters, you also need to
determine the values for these parameters:
• SIP Server IP Address
• Remote and Local SIP Port Numbers
• SIP User ID, and Authenticate ID and Password for this User ID
CyberData Corporation 930367H
Setting Up the V2 Paging Server
Configuring the V2 Paging Server
Operations Guide
10