2.4 Configuring the Paging Server
Use this section to configure the VoIP paging server.
2.4.1 Gather the Required Configuration Information
Have the following information available before you configure the Paging Server.
2.4.1.1 Static or DHCP Addressing?
Know whether your system uses static or dynamic (DHCP) IP addressing. If it uses static
addressing, you also need to know the values to assign to the following Paging Server parameters:
IP Address
●
Subnet Mask
●
Default Gateway
●
2.4.1.2 Username and Password for Configuration GUI
Determine the Username and Password that will replace the defaults after you initially log in to the
configuration GUI.
The Username is case-sensitive, and must be from four to 25 alphanumeric characters long.
●
The Password is case-sensitive, and must be from four to 20 alphanumeric characters long.
●
2.4.1.3 SIP Settings
To configure the SIP parameters, determine whether you want to register the server. If you do,
determine the number of minutes the registration lease remains valid, and whether you want to
automatically unregister when you reboot. To configure the SIP parameters, you also need to
determine the values for these parameters:
SIP Server IP Address
●
Remote and Local SIP Port Numbers
●
SIP User ID, and Authenticate ID and Password for this User ID
●
2.4.2 Log in to the Configuration GUI
To log in:
1. For the initial configuration of the Paging Server, open your browser and enter the following
address:
http://192.168.3.10
Note
VoIP Paging Server Operations Guide
To work with the Paging Server configuration after the initial configuration, log in using the
IP address you assign to the device.
provides instructions for entering the IP address.
930132F
Implementing the VoIP Paging Server
Section 2.4.3, "Configure the Network Parameters"
Configuring the Paging Server
CyberData Corporation
8
Need help?
Do you have a question about the 010878 and is the answer not in the manual?
Questions and answers