Deskset Installation (Set Static Ip) - VTech EriseBusinessSystem UP406 User Manual

4-line office phones deskset
Hide thumbs Also See for EriseBusinessSystem UP406:
Table of Contents

Advertisement

Getting started

Deskset installation (set static IP)

To set static IP when initially setting up the deskset:
Instructions on this page are for users to enter static IP to set up the
deskset, due to a failure in obtaining IP from the Ethernet switch or
router automatically. If you have successfully obtained the IP from your
Ethernet switch or router, you do not need to perform the steps below.
1. If the deskset cannot obtain an IP address from the Ethernet switch or router
after you power it up, the screen displays No IP obtained. Check network,
then displays the network setup menu.
2. Press
or
3. The screen displays Enter static IP Use the dialing keys to enter a
specific IP.
Press DELETE to delete a character.
Press # to add a dot.
Press /REPEAT or /SKIP to move the cursor to the left or right.
When entering a specific IP, make sure the IP range is not blocked by the
Ethernet switch or router. If you are installing more than one deskset in the
system, keep the first three sets of digits consistent and the last one different
among different desksets. For example, if you enter 192.168.1.1 as the static
IP of the first deskset, make sure the first three sets of digits are also set as
192.168.1 in other system desksets.
SELECT. The screen displays Subnet mask: Use the dialing
4. Press
MENU/
keys to enter a specific subnet mask.
Press DELETE to delete a character.
Press # to add a dot.
Press /REPEAT or /SKIP to move the cursor to the left or right.
SELECT. The screen displays Router/Gateway: Use the dialing
5. Press
MENU/
keys to enter a specific gateway.
Press DELETE to delete a character.
Press # to add a dot.
Press /REPEAT or /SKIP to move the cursor to the left or right.
SELECT to save. The screen displays IP obtained: XXX.
6. Press
MENU/
XXX.X.XXX Press SELECT to proceed, press
7. The deskset displays Enter the name of the Console connecting to this
phone. Press
(Continued on next page)
to scroll to Set static IP, then press
/SELECT.
MENU
MENU/
MENU
14
SELECT.
/SELECT.

Advertisement

Table of Contents
loading

Table of Contents