Adding And Registering A Cordless Headset - VTech EriseBusinessSystem UP406 User Manual

4-line office phones deskset
Hide thumbs Also See for EriseBusinessSystem UP406:
Table of Contents

Advertisement

Getting started

Adding and registering a cordless headset

You can use this deskset handsfree when you register a DECT 6.0 cordless
headset (IS6100, purchased separately) to the deskset. You can only register
one cordless headset to the deskset. Make sure the headset is charged before
use. Refer to the user's manual of the cordless headset for details.
Place the headset in the headset charger and note the color of the
If the button flashes in blue and red alternately, the headset is unregistered.
If the button shows a constant red light (charging) or a constant blue light (fully
charged), the headset is registered to other deivce. Deregister the headset
before you register it to the deskset. See the deregistration instructions in the
user's manual of the telephone to which it is currently registered.
To register an IS6100 cordless headset to your UP406 deskset
NOTE: Register each cordless handset or headset separately.
1. Place the headset in the headset charger and allow
it to charge for at least five minutes before beginning
registration. Make sure the headset is out of the
headset charger before you begin registration.
2. On the UP406 deskset, press MENU
3. Press
or
SELECT or /SKIP.
MENU/
4. Press
or
SELECT or /SKIP. The UP406 deskset
press
MENU/
shows Registering DECT Headset... (Put DECT
headset in charger) It takes up to 60 seconds to
complete the registration.
5. Place the headset into the cradle. The UP406
deskset shows DECT Headset registered when the
registration is successful.
6. Lift the headset, then press
the registration was successful.
If there is no dial tone, or the
alternately, the registration was not successful. Remove the headset from
the headset charger. Wait for about two minutes, then repeat the registration
process again, starting with Step 2 above.
to scroll to Registration and press
to scroll to DECT Headset, then
light on the headset flashes blue and red
/SELECT.
on the headset. If you hear a dial tone,
21
button.
One Touch
Phone Settings
System setup
>Registration
Registration
Handset
>DECT Headset
Deregistration
Registering
DECT Headset...
(Put DECT headset
in charger)

Advertisement

Table of Contents
loading

Table of Contents