20: Quadruple Tap Delay - Roland RS-5 Owner's Manual

20: QUADRUPLE TAP DELAY

The Quadruple Tap Delay has four delays.
fig.MFX-20a
L in
Delay 1
Feedback
Delay 2
Quadruple Tap Delay
Delay 3
Delay 4
R in
The stereo location of each delay sound is as follows.
fig.MFX-20b
2 3
1 4
R
L
Delay 1 (Delay Time 1)
Adjust the time delay from the direct sound until when delay
1 sound is heard.
Value: 200–1000 [ms], note-value symbols
Delay 2 (Delay Time 2)
Adjust the time delay from the direct sound until when delay
2 sound is heard.
Value: 200–1000 [ms], note-value symbols
Delay 3 (Delay Time 3)
Adjust the time delay from the direct sound until when delay
3 sound is heard.
Value: 200–1000 [ms], note-value symbols
Delay 4 (Delay Time 4)
Adjust the time delay from the direct sound until when delay
4 sound is heard.
Value: 200–1000 [ms], note-value symbols
Delay 1–4 parameters can be set as a note-value of a
specified tempo. In this case, specify the value of the
desired note. The Tempo (p. 76) setting changes to the
basic tempo.
Level 1
Adjust the volume of delay 1 sound.
Value: 0–127
Balance D
L out
Balance W
Balance W
R out
Balance D
Chapter 6. Effect Settings
Level 2
Adjust the volume of delay 2 sound.
Value: 0–127
Level 3
Adjust the volume of delay 3 sound.
Value: 0–127
Level 4
Adjust the volume of delay 4 sound.
Value: 0–127
Feedback (Feedback Level) #1
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Value: -98– +98 [%]
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Value: 200–8000 [Hz], BYPASS
Balance (Effect Balance) #
Adjust the volume balance between the direct sound and the
delay sound. With a setting of D100:0W only the direct sound
will be output, and with a setting of D0:100W only the delay
sound will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
95