15: Stereo Flanger - Roland RS-5 Owner's Manual

Chapter 6. Effect Settings
High Gain
Adjust the gain of the high frequency range.
Value: -15– +15 [dB]
Balance (Effect Balance) #2
Adjust the volume balance between the direct sound and the
chorus sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
chorus sound will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127

15: STEREO FLANGER

This is a stereo flanger. (The LFO has the same phase for left
and right.) It produces a metallic resonance that rises and
falls like a jet airplane taking off or landing. A filter is
provided so that you can adjust the timbre of the flanged
sound.
fig.MFX-15
Balance D
L in
Flanger
Feedback
Feedback
Flanger
R in
Balance D
Pre Delay (Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the flanger sound is heard.
Value: 0.0–100 [ms]
Rate #1
Adjust the rate of modulation.
Value: 0.05–10.00 [Hz]
Depth
Adjust the depth of modulation.
Value: 0–127
90
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Feedback (Feedback Level) #2
Adjust the amount (%) of the processed sound that is
returned (fed back) into the input. Positive (+) settings will
return the sound in phase, and negative (-) settings will
return the sound in reverse phase.
Value: -98– +98 [%]
Phase
Adjust the spatial spread of the sound.
Value: 0–180 [deg]
Filter Type
Select the type of filter.
OFF: a filter will not be used
LPF: cut the frequency range above the cutoff frequency
HPF: cut the frequency range below the cutoff frequency
Cutoff Freq (Cutoff Frequency)
Adjust the basic frequency of the filter.
Value: 200–8000 [Hz]
Low Gain
Adjust the gain of the low frequency range.
Value: -15– +15 [dB]
High Gain
Adjust the gain of the high frequency range.
Value: -15– +15 [dB]
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
flanger sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
flanger sound will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127