Setting The Chorus Depth For Each Part; Making Reverb Settings; Selecting The Type And Setting Each Parameter - Roland RS-5 Owner's Manual

Chapter 6. Effect Settings
Delay (Chorus Delay Time)
Sets the delay time of the chorus effect.
Value: 0–127
Rate (Chorus Rate)
Sets the speed (frequency) at which the chorus sound is
modulated. Higher values result in faster modulation.
Value: 0–127
Depth (Chorus Depth)
Sets the depth at which the chorus sound is modulated.
Higher values result in deeper modulation.
Value: 0–127
Send levl to Rev (Chorus send level to reverb)
Sets the amount of chorus sound that will be sent to the
reverb. Higher values result in more sound being sent.
Value: 0–127
Setting the Chorus Depth for Each
Part
Send Level (Chorus send level)
Sets the amount of chorus effect applied in each Part.
Value: 0–127
1. Press [EDIT], getting the indicator to light.
2. Use VALUE [-]/[+] to select "Performance Part."
3. Press [ENTER].
4. Press PART [
]/[
5. Press the numeric key [7] several times to select "Send
Level"
fig.R06-06
6. Use VALUE [-]/[+] to select the value (0–127).
7. Press [EDIT].
The [EDIT] indicator goes out, and you are returned to
the previous screen.
108
] to select the Part.

Making Reverb Settings

You can make different Reverb settings for each individual
Performance.
There are eight types of reverb. You can select any one of
these. After selecting the Type, you can change the values for
each of the parameters.
Furthermore, you can make different reverb depth (the
amount applied) settings for each individual Part in a
Performance.
Selecting the Type and Setting
Each Parameter
When you change the Reverb Type, six different reverb
parameters, including Reverb character, are changed
automatically to the optimum values. Rather than setting the
reverb parameters one by one, you can make the settings
more easily by first setting the Reverb Type and then
changing only the necessary parameters.
These settings can be made differently for each individual
Performance.
1. Press [EDIT], getting the indicator to light.
2. Use VALUE [-]/[+] to select "Tone/Drum/
PFMCommon."
3. Press [ENTER].
4. Press the numeric key [8] several times to select the item
you wish to set.
fig.R06-07
* If you hold down [SHIFT] and press [8], you will return to the
previous item.
5. Use VALUE [-]/[+] to set the value.
* If you wish to make settings for other Parts, repeat steps 4–5.
6. Press [EDIT].
The [EDIT] indicator goes out, and you are returned to
the previous screen.