Chapter 6. Effect Settings; Turning The Effect Function On And Off (Effects On/Off) - Roland RS-5 Owner's Manual

Chapter 6. Effect Settings

The RS-5/9 contains three effects processors: multi-effects,
chorus, and reverb. Settings can be made separately for each
effects processor.
There are 42 types of multi-effects, 8 types of chorus, and 8
types of reverb. You can use one of each type in a
Performance.
Turning the Effect Function On
and Off (EFFECTS ON/OFF)
In order to enable an effects processor (multi-effects, chorus,
reverb), turn its switch on.
Turn these settings off when you wish to listen to the
unprocessed sound as you create a sound, or when you wish
to use external effect devices instead of the built-in effects.
The On/Off settings for each Effect affect the RS-5/9 as a
whole (i.e., are system settings). This setting remains stored
in memory even while the power is off.
When shipped from the factory, all three effects are set to ON.
1. Press [EFFECTS ON/OFF], getting its indicator to start
blinking.
The Multi-effects On/Off settings screen appears in the
display.
fig.Q-48
2. Press VALUE [-]/[+] to turn the effect on or off.
3. Press [EFFECTS ON/OFF].
Next, the Chorus On/Off settings screen appears in the
display.
fig.Q-49
4. Press VALUE [-]/[+] to turn the effect on or off.
5. Press [EFFECTS ON/OFF].
Next, the Reverb On/Off settings screen appears in the
display.
fig.Q-50
6. Press VALUE [-]/[+] to turn the effect on or off.
7. Press [EFFECTS ON/OFF] to return to the original
screen.
The [EFFECTS ON/OFF] indicator lights up whenever
any of the three effects is on.
* You can return to the original screen during the operation by
pressing [EXIT].
* If all three effects are turned off, the [EFFECTS ON/OFF]
indicator light goes out.
79