16: Step Flanger - Roland RS-5 Owner's Manual

16: STEP FLANGER

The Step Flanger effect is a flanger in which the flanger pitch
changes in steps.
fig.MFX-16
Balance D
L in
Step Flanger
Feedback
Feedback
Step Flanger
R in
Balance D
Pre Delay (Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the flanger sound is heard.
Value: 0.0–100 [ms]
Rate
Adjust the rate of modulation.
Value: 0.05–10.00 [Hz]
Depth
Adjust the depth of modulation.
Value: 0–127
Feedback (Feedback Level) #1
Adjust the amount (%) of the flanger sound that is returned
(fed back) into the input. Negative (-) settings will invert the
phase.
Value: -98– +98 [%]
Phase
Adjust the spatial spread of the sound.
Value: 0–180 [deg]
Step Rate #2
Adjust the rate (period) of pitch change.
Value: 0.1–20.0 [Hz], note-value symbols
Step Rate parameter can be set as a note-value of a
specified tempo. In this case, specify the value of the
desired note. The Tempo (p. 76) setting changes to the
basic tempo.
Low Gain
Adjust the gain of the low frequency range.
Value: -15– +15 [dB]
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Chapter 6. Effect Settings
High Gain
Adjust the gain of the high frequency range.
Value: -15– +15 [dB]
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
flanger sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
chorus sound will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
91