Roland RS-50 System Update

Hide thumbs Also See for RS-50:

RS-50 System Update

Note: Updating the operating system will erase all custom User settings. Please

back up all important User information before performing the system update.

1. RS-50

2. MIDI Sequencer or software program capable of playing Standard MIDI

Files

3. MIDI cable

4. Update Files

1. Connect the MIDI Out of the sequencer to the MIDI In of the RS-50.

2. Power On the RS-50 while holding "KEY MODE" and "ENV or

BALANCE/LFO."

The following screen will be displayed

3. Press "1 Piano."

The following screen will be displayed

4. Send all 29 ".mid" update files in consecutive order.

Note: While the RS-50 is receiving data the display will show "Receiving."

5. Once all data has been sent, the 1 Piano and 2 Key&Org buttons will blink

and the following will be displayed:

6. Power Off the RS-50.

7. Power On to resume and proceed to the steps on performing the "Factory

Reset."

Table of Contents

Do you have a question about the RS-50 and is the answer not in the manual?

Page 1 3. MIDI cable 4. Update Files Update Procedure: 1. Connect the MIDI Out of the sequencer to the MIDI In of the RS-50. 2. Power On the RS-50 while holding “KEY MODE” and “ENV or BALANCE/LFO.” The following screen will be displayed 3.
Page 2 4. Press ENTER again to confirm. Note: The Factory Rest process will take about 30 seconds to complete. During this time NEVER power down the unit. 5. Once “Completed” is displayed, your may resume normal operation. © 2005 Roland Corporation U.S.