Table of Contents
Advertisement
Modulation FX Parameters
20: STEP FLANGER
This is a flanger in which the flanger pitch changes in steps. The
speed at which the pitch changes can also be specified in terms of a
note-value of a specified tempo.
L in
Step Flanger
Feedback
Feedback
Step Flanger
R in
Parameter
Value
Switch
OFF, ON
Depth Knob
RATE,
FEEDBACK,
STEP RATE,
BALANCE
Rate Knob
OFF,
Filter Type
LPF,
HPF
Cutoff Freq
200–8000 [Hz]
Pre Delay
0.0–100 [msec]
Rate (sync sw) #
OFF, ON
0.05–10.00 [Hz]
Rate (Hz) #/
Rate (note) #
note (p. 31)
Depth
0–127
Phase
0–180 [deg]
Feedback #
-98–+98 [%]
Step Rate
OFF, ON
(sync sw) #
0.10–20.00 [Hz]
Step Rate (Hz) #/
Step Rate (note)#
note (p. 31)
Low Gain
-15–+15 [dB]
High Gain
-15–+15 [dB]
D100:0W–
Balance #
D0:100W
Level
0–127
14
Balance D
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Balance D
Explanation
Turns the effect on/off.
Specifies the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Specifies the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Type of filter
OFF: no filter is used
LPF: cuts the frequency range above
the Cutoff Freq
HPF: cuts the frequency range below
the Cutoff Freq
Basic frequency of the filter
Adjusts the delay time from the direct
sound until the flanger sound is heard.
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner's manual p. 24).
Frequency of modulation
Depth of modulation
Spatial spread of the sound
Adjusts the proportion of the flanger
sound that is fed back into the effect.
Negative "-" settings will invert the
phase.
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner's manual p. 24).
Rate (period) of pitch change
Gain of the low range
Gain of the high range
Volume balance between the direct
sound (D) and the flanger sound (W)
Output Level
21: HEXA-CHORUS
Uses a six-phase chorus (six layers of chorused sound) to give
richness and spatial spread to the sound.
L in
Balance D
Hexa Chorus
R in
Balance D
Parameter
Value
Switch
OFF, ON
Depth Knob
RATE,
BALANCE
Rate Knob
Pre Delay
0.0–100 [msec]
Rate (sync sw) #
OFF, ON
0.05–10.00 [Hz]
Rate (Hz) #/
Rate (note) #
note (p. 31)
Depth
0–127
Pre Delay
0–20
Deviation
Depth Deviation -20–+20
Pan Deviation
0–20
D100:0W–
Balance #
D0:100W
Level
0–127
L out
Balance W
Balance W
R out
Explanation
Turns the effect on/off.
Specifies the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Specifies the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Adjusts the delay time from the direct
sound until the chorus sound is heard.
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner's manual p. 24).
Frequency of modulation
Depth of modulation
Adjusts the differences in Pre Delay
between each chorus sound.
Adjusts the difference in modulation
depth between each chorus sound.
Adjusts the difference in stereo
location between each chorus sound.
0: All chorus sounds will be in the
center.
20: Each chorus sound will be spaced
at 60 [deg]ree intervals relative to
the center.
Volume balance between the direct
sound (D) and the chorus sound (W)
Output Level
Advertisement
Table of Contents
