User Program Mode; Preliminary Information; Accessing User Program Mode - Gemini GEM-P9600 Programming Instructions Manual

!
Page 64

USER PROGRAM MODE

PRELIMINARY INFORMATION

The User Program Mode is covered in detail in the operating instructions for the keypad in use.
!
Only Keypad #1 may be used for programming, however this keypad may be located in any area.
!
The Program Mode cannot be accessed while the communicator is transmitting except during the first three minutes after power-up.
!
After entering codes or data, press the save
!
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound.
!
Press the C button to silence the sounder and exit the User Program Mode.
NOTE: For ease of programming, it is recommended that a GEM-RP1CAe2 or GEM-K1CA be used as Keypad #1. (A new GEM-
RP1CAe2/GEM-K1CA is automatically configured as Keypad #1). See Keypad Configuration Mode and WI777 for more information.
If a GEM-K2AS or GEM-RP2ASe2 keypad is used, configure address jumpers as Keypad #1 (see page 64, "Configuring the
Keypads"). Use the
R

ACCESSING USER PROGRAM MODE

1. Press EEEEEE
2. Press Q
3. Press P
4. Press C
X
GEM-P9600 Programming Instructions
U
button. Data will not be stored into memory unless this button is pressed.
or button to manually scroll the display at the end of each programming line.
A
New Panel (Default User Code = 123)
Existing Panel (Any Code with User Program Option Enabled)
Until "TURNON PROG Y/N" (GEM-RP2ASe2/GEM-K2AS) or
"17" (GEM-RP3DGTL/GEM-K3DGTL or GEM-RP4RFC/
GEM-K4RF) appears on the LCD screen.
To Enter User Program Mode.
To Exit User Program Mode when finished.
WI 1185 6/03
R
L
NAPCO Security Systems