!
Page 22
DIRECT ADDRESS PROGRAM MODE
This is an extension of the Dealer Program Mode. This method of programming is used in conjunction with the Keypad
Programming Worksheets that follow. Refer to these worksheets to identify the 4-digit location (address) of the feature
to be programmed. An illustrative example is provided on the next page.
DATA ENTRY
ADDRESS
LOCATIONS
LOCATIONS
LEFT DIGIT
3
0000
0000
HEXADECIMAL DATA:
TO
•
BLANK (•) = No Options
4095
•
1 to 9 = Entries 1 to 9
•
0 = Entry of 10
•
B to F = Entries 11 to 15
ACCESSING DIRECT ADDRESS PROGRAM MODE
1. Press
EEEEEE
2. Press the PRIOR/NO (Q) button until:
"TURNON PROG Y/N" (GEM-RP2ASe2/GEM-K2AS)
"17" (GEM-RP3DGTL/GEM-K3DGTL or GEM-RP4RFC/GEM-
K4RF) appears on the keypad display.
3. Press the NEXT/YES (P) button to enter Dealer Program Mode.
(The panel and keypad version appears briefly on the keypad display).
4. Press C to exit Easy Menu Driven Program Mode & enter
Direct Address Program Mode.
(For keypad display examples when in Program Mode, see next page).
X
GEM-P9600 Programming Instructions
KEYPAD PROGRAMMING OVERVIEW
Direct Address Programming allows you to go directly to the address
RIGHT DIGIT
locations and change the data entries to customize your control
C
panel options. Whereas the Easy Menu Program Mode is a simple
quick start guide with limited options, the Direct Address Program
Mode is more flexible allowing you to change all the options.
It consists of multiple address locations with two data entry locations
each (left and right) as shown in the adjacent diagram.
Master Security Code
(on microshield)
--or--
R
L
WI 1185 6/03
GEM-P3200
GEM-P9600
CONTROL
R
COMMUNCIATOR
MASTER SECURITY CODE
# - # - # - # - # - #
NAPCO Security Systems