Table of Contents
Advertisement
WI818D 8/00
GEMINI
SYSTEM ARMED
USER PROGRAM MODE
# OF ZONES IN AREA 1
ENTER USER CODE
01/01/97 12:00AM
U01 123___ - _1 - __
ENTER # ZONES X X
NEXT/YES
A
1 2
3
E
D
PRIOR/NO
B
4
5 6
F
AREA
C
7 8 9 0
G
COMPUTERIZED SECURITY SYSTEM
R
PRELIMINARY INFORMATION
The User Program Mode is covered in detail in the operating instructions for the keypad in use.
!
Only Keypad #1 may be used for programming, however this keypad may be located in any area.
!
The Program Mode cannot be accessed while the communicator is transmitting except during the first three minutes after power-
up or while any area is armed.
!
After entering codes or data, press the save
!
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound. Press the
C
button to silence the sounder and exit the User Program Mode.
NOTE: For ease of programming, it is recommended that a GEM-RP1CAe2 be used as Keypad #1. (A new GEM-RP1CAe2 is
automatically configured as Keypad #1.)
If a GEM-RP2ASe2 is used, configure address jumpers as Keypad #1 (see the section of this manual Configuring the GEM-
RP2ASe2 Keypad). Use the
ACCESSING USER PROGRAM MODE
1. Press EEEEEE A
2. Press g Until "ACTIVATE PROGRAM Y/N" (GEM-RP1CAe2) or
3. Press F To Enter User Program Mode
4. Press C To Exit User Program Mode when finished
USER CODES
ENTER USER CODE
U01 123___ -_ _ -__
GEM-RP1CAe2 Keypad (Direct Entry)
Up to 48 User Codes may be programmed.
NOTE: In this mode, only the code is
programmable; the accompanying Area Options
must be programmed in the Dealer Program
Mode (see page 9).
!
Use the
A
button to place the cursor
over the User Number.
!
Enter a User Number (01–48) using the
number buttons. The cursor will then
advance to the User Code and read the
existing code, if any.
L
NAPCO Security Systems
J
button. Data will not be stored into memory unless this button is pressed.
button to manually scroll the display at the end of each programming line.
A
New Panel (Default User Code = 123)
Existing Panel (Any Code with User Program Option Enabled)
"TURNON PROG Y/N" (GEM-RP2ASe2)
appears on LCD screen.
To Program User Codes
1. Set Cursor Position using
the
A
2. Enter 2-digit User Number
(01-96) directly using
number buttons (0-9).
3. Enter Code (1-6 digits)
directly using number
buttons (0-9).
4. Press the
each code.
NOTE: Press
button.
J
button to save
G 0 button to clear character at cursor.
To continue press E or F button.
Programming User Codes
X
GEM-P3200 Programming Instructions
Page 61
User Code
NOT USED
!
Advertisement
Table of Contents
