Enable No Eolr Zones; Enable Telco Line Fault Test; Enable Burg Output Chirp On Keyfob; Enable Sia Cp-01 Features - Gemini GEM-P9600 Programming Instructions Manual

!
Page 8
Enable No EOLR Zones (New Program Only)
EnNEOL
•
•
Y/N
(Press YES or NO)

Enable Telco Line Fault Test?

Telco
•
•
Ln Flt
Y/N
(Press YES or NO)

Enable Burg Output Chirp on KeyFob?

KF Out
•
•
Chirp
NOTE: The Burg Output will chirp once on Keyfob Arm and twice on Keyfob Disarm.
Y/N
(Press YES or NO)

Enable SIA CP-01 Features?

Enable
•
•
CP01?
The SIA CP-01 Features are designed to reduce the incidence of false alarms. NOTE: Do not enable unless reporting,
otherwise system trouble Fail to Communicate may occur.
Y/N
(Press YES or NO)

Number of Keypads in Area 1

•
Ent A1
•
#KP 01
Press
(Direct Entry)

Number of Keypads in Area 2

•
Ent A2
•
#KP 01
Press
(Direct Entry)
Central Station Receiver 1 Telephone Number
•
Phone#
•
_ _ _ _ _ _
•
•
_ _ _ _ _ _
•
(Direct Entry)
X
GEM-P9600 Programming Instructions
Press YES to program all zones except 24 Hr & fire zones for No End Of Line Resistor. Press NO to continue.
Do not program this feature for UL Installations.
Press YES to enable Telco Line Fault Test.
Press NO to continue. NOTE: If enabled, a Telco Line Fault Test Delay of 60 sec. will automatically be programmed.
Press the NEXT/YES button to enable Burg Output Chirp on KeyFob Arm / Disarm.
Press the PRIOR/NO button to continue.
Press the NEXT/YES button to enable.
Press the PRIOR/NO button to continue.
Enter the total number of Keypads to be installed in Area 1.
Valid entries are from 01 to 15. Directly enter the number of keypads, including leading zeros.
U
to save. Press the NEXT/YES button to proceed.
Enter the total number of Keypads to be installed in Area 2.
Valid entries are from 01 to 15. Directly enter the number of keypads, including leading zeros.
U
to save. Press the NEXT/YES button to proceed.
Enter telephone number of up to 16 digits.
Press 1 through 9 for digits 1–9;
Press G 1 through G 5
Pre-Dial Delay = "D" ( G 4
U
Press to save and press the NEXT/YES button to proceed.
NOTE: Central Station Receiver 2 and 3 Telephone Numbers must be entered in Direct Address Program-
ming. See CS Receiver Options.
G 0 for a zero and
for letters B–F, respectively.
); Dial-Tone Detection = "E" ( G 5
WI 1185 6/03
•
0 for a blank ( ).
).
L
NAPCO Security Systems