Front Drive Shaft Inspection - Suzuki kq500 Service Manual

3A-5 Drive Chain / Drive Train / Drive Shaft:
8) Install the circlip (2) into the groove of front drive
shaft spline.
CAUTION
!
The removed circlip must be replaced with a
new one.
9) Inspect the axle play by using a push-and-pull
motion given to the axle shaft and wheel spindle.

Front Drive Shaft Inspection

Inspect the front drive shaft in the following procedures:
1) Remove the front drive shaft assembly. Refer to
2) Check the driveshaft boots for twist and grease leak.
3) Inspect the boots, circlip and boot bands for wear or
2
I931H1310007-01
4) Install the front drive shaft assembly. Refer to "Front
I931H1310008-01
"Front Drive Shaft Assembly Removal and
Installation (Page 3A-2)".
If any defects are found, replace the defective parts
with new ones.
damage. If any damages are found, replace them
with new ones.
Drive Shaft Assembly Removal and Installation
(Page 3A-2)".
B931H23106004
I931H1310009-01