Fuel Tank Pressure Control (Ftpc) Valve Removal And Installation - Suzuki kq500 Service Manual

Fuel Tank Pressure Control (FTPC) Valve
Removal and Installation
Removal
1) Remove the rear carrier. Refer to "Rear Carrier
Removal and Installation: in Section 9E".
2) Remove the seat. Refer to "Seat Removal and
Installation: in Section 9D".
3) Remove the side covers, left and right. Refer to
"Front Side Exterior Parts Removal and
Installation: in Section 9D".
4) Remove the engine side cover. Refer to "Rear Side
Exterior Parts Removal and Installation: in
Section 9D".
5) Remove the mud guard mounting screws (1) and
fasteners (2).
2
B931H21706016
1
I931H1170023-03
2
1
I931H1170026-03
6) Remove the fuel tank cap (3).
CAUTION
!
To prevent the fuel tank from contamination
with foreign particles, blind opening.
7) Move the rear fender upside.
8) Disconnect the check valve hose (4) and fuel tank
breather hose (5).
9) Remove the FTPC valve (6).
4
Installation
Install the FTPC valve in the reverse order of removal,
pay attention to the following points.
• Install the FTPC valve as shown in the fuel tank
breather hose routing diagram. Refer to "Fuel Tank
Breather Hose Routing Diagram (Page 1G-4)".
Fuel System: 1G-12
3
I931H1170024-03
6
5
I931H1170025-04