Final Gear Shim Inspection And Selection - Suzuki kq500 Service Manual

3B-33 Differential:
Final Driven / Drive Gear Bering
Inspect the bearings for abnormal noise and smooth
rotation. Replace the bearings if there is anything
unusual.
Final Drive Gear
Inspect the final drive gear for wear or damage.
Inspect the final drive gear bearing for abnormal noise
and smooth rotation. If any defects are found, replace
defective parts.
Final Driven Gear
Inspect the final driven gear for wear or damage. If any
defects are found, replace drive and driven gear as a
set.
I831G1320128-01

Final Gear Shim Inspection and Selection

Refer to "Final Gear Assembly Removal and Installation
(Page 3B-25)".
Backlash
• Install the shim(s), final drive gear assembly and new
final drive gear bearing stopper.
• Tighten the final drive gear bearing stopper (1) to the
specified torque with the special tool.
NOTE
I831G1320129-01
As this time, it is not necessary to bend the
bearing stopper collar.
Special tool
(A): 09924–41830 (Bearing retainer wrench
(50 mm))
Tightening torque
Final drive gear bearing stopper (a): 100 N·m (
10.0 kgf-m, 72.5 lbf-ft)
I831G1320130-01
I831G1320131-01
B931H23206019
(A)
1
(a)
I831G1320132-01