Combination Meter Disassembly And Assembly; Combination Meter Inspection; Engine Coolant Temperature Indicator Light Inspection - Suzuki kq500 Service Manual

9C-3 Combination Meter / Fuel Meter / Horn:
2) Remove the combination meter mounting bolt.
3) Disconnect the combination meter coupler (5) and
remove the combination meter assembly.
5
Installation
Install the combination meter in the reverse order of
removal. Pay attention to the following points:
• Make sure that speedometer coupler boot is
positioned properly.

Combination Meter Disassembly and Assembly

Refer to "Combination Meter Removal and Installation
(Page 9C-2)".
CAUTION
!
Do not attempt to disassemble the
combination meter unit.
Disassembly
Disassemble the combination meter as shown in the
combination meter components. Refer to "Combination
Meter Components (Page 9C-2)".
I931H1930003-01
Assembly
Assemble the combination meter as shown in the
combination meter components. Refer to "Combination
Meter Components (Page 9C-2)".

Combination Meter Inspection

LED Inspection
Check that the LEDs (Diff-lock indicator light, Reverse
indicator light and FI indicator light/Engine coolant
temperature indicator light) immediately light up for two
seconds when the ignition switch is turned to ON.
Check that other LEDs (Neutral indicator light and High-
beam indicator light (for P-17)) light up/go off by
I931H1930004-01
operating each switch.
If abnormal condition is found, replace the combination
meter unit with a new one after checking its wire
harness/coupler. Refer to "Combination Meter Removal
and Installation (Page 9C-2)".
Engine Coolant Temperature Indicator Light
I931H1930005-01
Inspection
Inspect the engine coolant temperature indicator light in
the following procedures:
1) Remove the seat. Refer to "Seat Removal and
Installation: in Section 9D".
2) Remove the left side cover. Refer to "Front Side
Exterior Parts Removal and Installation: in
Section 9D".
B931H29306003
B931H29306004
I931H1930018-01
B931H29306005