Move+Insert - Akai DR16 pro Operator's Manual

11: Editing
7) Use the CHANNEL ON keys (and the 9-16 key, if necessary) to select the move source
tracks.
8) Use the TRACK REC(INPUT SELECT) keys (and the 9-16 key, if necessary) to select the
move destination tracks.
9) Press the STORE/ENT key to execute the move.
When the DR16pro has completed the move operation, the message will momentarily appear
on the display. The LED beside the EDIT key will switch off and the previous mode will be
restored.

Move+Insert

The move+insert function works basically the same as the move function. However, unlike move,
the move+insert function moves any existing material at the specified destination behind the new
material rather than overwriting it. The following diagram illustrates the move+insert procedure:
Source and Destination Track
"in" point
Source Track
Destination Track
The following steps are similar to "Copy" on page 86, therefore only an outline is provided here.
1) Set the "in" and "out" points to define the move source section.
See "Specifying the "in" Point and "out" Point" on page 26.
2) Locate to the desired position for the destination insert point.
Refer to the "Locate Functions" on page 77.
3) Press the EDIT key to enter Edit Mode.
The EDIT indicator will light up
4) Use the JOG/SHUTTLE control to select the Move+Insert function.
You will see a display similar to the following:
Source
Destination insert point
"out" point
Source
Destination insert point
TIME
ABS
EDIT
Page 90
Section
Section