7: Mixer
Inserting Snapshots
1)
Check your snapshot map.
Use the steps shown in "Checking Snapshots" on page 69.
2)
Locate to another point.
3)
Use the JOG/SHUTTLE control to select the snapshot you want to assign and press the
STORE/ENT key.
The snapshot numbers are assigned by the location of the snapshot on the time axis. When
you assign a new snapshot to a locate point earlier than an existing snapshot, the new snap-
shot is given the existing number. The subsequent snapshot numbers are updated.
Erasing Snapshot Locations
1)
Press the SUB-MENU key.
The indicator in the key will flash and the text "SU B-ME N U " will appear on the display.
2)
Press the SNAPSHOT(MAP) key.
3)
Rotate the SHUTTLE control to move the cursor to the step number.
The step number will be underlined: " 0 0 1- S N AP42 ".
4)
Rotate the JOG wheel to select the desired step number.
5)
Press the REC
The selected snapshot will be erased and the subsequent step numbers will be updated.
Note: Erasing a snapshot only removes the snapshot from the time axis. The snapshot
data is still stored in memory and can be recalled. See "Recalling a Snapshot" on page 68.
Note: You cannot delete the initial snapshot number 01.
key.
Page 70