Other Take Applications - Akai DR16 pro Operator's Manual

8: Take Functions

Other Take Applications

Storing Specific Tracks or Sections
You can store a track, a section of a track, or a set of tracks to a take.
1) Make a recording of some material.
After the recording is made, the corresponding TRACK REC key will light, to show which
tracks contain data. You can choose which tracks to store.
2) If you wish to specify a section of a track, assign IN and OUT points to specify the
appropriate section.
( See "Specifying the "in" Point and "out" Point" on page 26.)
3) Press the RESERVED key.
The red LED beside the RESERVED key flashes and the green LEDs beside the available
TAKE keys flash. The LEDs beside TAKE keys with data are turned off. The LED over the
CHANNEL ON keys for tracks that contain data will light.
The message "R E SE RVE D " will appear on the display.
4) Press the appropriate TRACK REC key (or keys) to turn off unwanted tracks.
5) Press the TAKE key you want to use to store the recording.
When the take is stored, the LED lights up beside the corresponding TAKE key.
Committing Specific Tracks
You can commit a specific track or set of tracks from a take.
1) Press the COMMIT key.
The message "C OM M I T " will appear on the display.
2) Press the TAKE key that contains the part you want to commit to the track.
The message "S U R E ? ? " will appear on the display.
3) Press the appropriate TRACK REC key(s) to turn off tracks you do not want to commit.
4) Press the STORE/ENT key to confirm.
TRACK REC/INPUT SELECT
METER 1/9 2/10 3/11 4/12
CHANNEL ON
DIGI
1/9 2/10 3/11 4/12
D IN
Page 76
8/16
5/13 6/14 7/15
8/16
5/13 6/14 7/15