Copy+Insert - Akai DR16 pro Operator's Manual

11: Editing
Executing the Copy
1) Press the STORE/ENT key to execute the copy.
When the DR16pro has completed the copy operation, the message "D ON E " will momen-
tarily appear on the display.
The LED beside the EDIT key will switch off and the previous mode restored.

Copy+Insert

The copy+insert function works basically the same as the copy function. However, unlike copy, the
copy+insert function moves any existing material at the specified destination behind the new ma-
terial rather than overwriting it. The following diagram illustrates the copy+insert procedure:
Source and Destination Track
"in" point
Source Track
Destination Track
The following steps are similar to the operation detailed in "Copy" on page 86. Only an outline is
provided here. Refer to the previous steps for explanations.
1) Set the "in" and "out" points to define the copy source section.
See "Specifying the "in" Point and "out" Point" on page 26.
2) Locate to the desired position for the destination insert point.
Refer to the "Locate Functions" on page 77.
3) Press the EDIT key to enter Edit Mode.
The EDIT indicator will light up
4) Use the JOG/SHUTTLE control to select the Copy+Insert function.
You will see a display similar to the following:
5) Press the STORE/ENT key.
6) Use the JOG/SHUTTLE control to specify the number of repeats.
Section
"out" point Destination insert point
Section
Destination insert point
TIME
ABS
EDIT
Page 88
Copy
Copy