Insert - Akai DR16 pro Operator's Manual

5) Press the STORE/ENT key.
6) Use the JOG/SHUTTLE control to specify the number of repeats.
7) Use the CHANNEL ON keys (and the 9-16 key, if necessary) to select the move source
tracks.
8) Use the TRACK REC(INPUT SELECT) keys (and the 9-16 key, if necessary) to select the
move destination tracks.
9) Press the STORE/ENT key to execute the move.
When the DR16pro has completed the move operation, the message "D O N E" will momen-
tarily appear on the display. The LED beside the EDIT key will switch off and the previous
mode will be restored.

Insert

The insert function allows you to place a blank section into a track, similar to inserting a length of
leader tape. You could also use it to time-correct a track by pushing the material back. The follow-
ing diagram illustrates the insert procedure:
Insert track
Insert point
After insert
This procedure is different than the preceding edit functions because you do not need to set an "in"
point or "out" point.
1) To set the insert point, locate to the desired position.
Refer to the "Locate Functions" on page 77.
2) Press the EDIT key to enter Edit Mode.
The EDIT indicator will light up
3) Use the JOG/SHUTTLE control to select the Insert function.
You will see a display similar to the following:
TIME
ABS
EDIT
Page 91
11: Editing