Akai DR16 pro Operator's Manual page 120

3) Select "S C S I " with the JOG/SHUTTLE control then press the STORE/ENT key.
The message "T R A N SM I T" will appear in the display.
4) Select "T R A N S M I T " with the JOG/SHUTTLE control (if not already selected) and
then press the STORE/ENT key.
The message "T A P E I D 0 " will be displayed. This is the SCSI ID number of the SCSI
Tape Drive that is to be formatted.
5) Select the SCSI ID number of the SCSI Tape Drive using the JOG/SHUTTLE control
and press the STORE/ENT key.
The message "ENTIRE 0" will appear in the display.
6) Select the SCSI ID of the hard disk that is to be backed up using the JOG/SHUTTLE
control.
Select "0" to backup the internal hard disk.
7) Select the type of backup mode ("ENTIRE" or "PROJECT") with the JOG/SHUTTLE
control then press the STORE/ENT key.
EN T IR E..........to backup the entire contents of disk
PR O J EC T .......to backup by the project
8) When P ro JE C T is selected in step 7 above, select the project name you want to
backup using the JOG/SHUTTLE control and then press the STORE/ENT key to start
the backup.
When the backup is completed, the message "D ON E " will be displayed momentarily, then
it resumes normal mode operation.
Press the ESCAPE key to abort backup operation.
Note 1: If the tape in the SCSI Tape Drive is write protected, the message "TAPE
appear on the display and the backup operation will pause allowing you to eject the tape and
disable its write protect tab. Press the STORE/ENT key to continue the backup operation, after
disabling the write protecting tab (or ESCAPE to abort).
Note 2: If the tape already contains backup data, the message "TAPE U SED" will appear in
the display and the backup operation will be aborted automatically.
Note 3: If the tape is not formatted, the message "RE FORMAT" will appear in the display.
The tape will be formatted when the STORE/ENT key is pressed. ALL DATA ON THE TAPE
WILL BE ERASED!!
Page 111
13: Backup and Restore
Pr oT" will