Akai DR16 pro Operator's Manual page 117

12: Hard Disks
10) Press the STORE/ENT key again to start copying.
As the DR16pro copies the disk, the message "C O P Y I N G " will appear on the display.
When the copy function is complete, the message "D ON E " will appear on the display.
The previous mode will be restored.
Note: If you selected a source or destination SCSI ID that had no corresponding disk, an
error message will appear on the display.
Disk Copy Notes
You cannot playback recorded data on the DR16pro if you have changed the disk SCSI ID. See
"SCSI IDs" on page 98.
When the DR16pro records data to a hard drive, it includes the SCSI ID in the data. If you copy
data from one disk to another (for example, you copy data from disk ID 0 to disk ID 1) the data is
copied with the destination disk SCSI ID (that is, the data is recorded as being from disk ID 1).
Copying a project
You can copy projects one by one from the current disk to another disk.
Note: No data will be erased from the destination disk by the Project Copy operation; new data
will be added to the disk.
Note: You cannot use the Copy Project function to duplicate a project on the same hard disk.
To accomplish this, you must instead assign the project to a take, create a new project, and
commit the take. See "Projects" on page 54.
To copy a project to another disk:
1) Follow steps 1) through 7) of the Disk Copy procedure.
See "Copying an entire disk" on page 107.
2) Press the STORE/ENT key.
The message "E N T I R E " will appear on the display.
3) Use the JOG wheel to select "Pr o J E C T ".
4) Press the STORE/ENT key.
The display will show the name of projects that exist on the copy source disk.
5) Rotate the JOG wheel to select a project you wish to copy.
6) Press the STORE/ENT key.
The message "S U R E ? ? " will appear on the display.
If you change your mind, press the ESCAPE key to cancel the Copy operation.
7) Press the STORE/ENT key again to start copying.
As the DR16pro copies the project, the message "C O P Y I N G " will appear on the display.
When the copy function is complete, the message "D O N E" will appear on the display. The
previous mode will be restored.
Note: If you selected a source or destination SCSI ID that had no corresponding disk, an
error message will appear on the display.
Page 108