Akai DR16 pro Operator's Manual page 128

4) Use the JOG/SHUTTLE control to select the type of sync mode.
SMPTE/EBU
MIDI Clock
MIDI Timecode
MIDI Machine Control
In this case, select "S M P T E - L T C " to use SMPTE/EBU synchronization.
5) Press the STORE/ENT key to store your choice.
6) Use the JOG/SHUTTLE control to select the mode status.
Select OFF, MASTER, or SLAVE. The default is OFF. If you select the default, the DR16pro
returns to the previous mode.
7) Press the STORE/ENT key.
The display will show the current timecode type.
8) Use the JOG/SHUTTLE control to select a timecode type.
Timecode Type
24 frames/sec
25 frames/sec
30 frames/sec
30 drop frames/sec
29.97 frames/sec
29.97 drop frames/sec
9) Press the STORE/ENT key to store your choice.
SMPTE-LTC Slave Synchronization
1) Press the SYNC key to turn on the synchronization function.
The green LED beside the key will light.
2) Press the Play
The DR16pro will locate to the external timecode position immediately and synchronization
will start.
Synchronization with an Offset
During SMPTE-LTC slave synchronization, the DR16pro synchronizes to the received timecode
and that time value is displayed. Using the relative time display allows timecode-synchronized
operation with an offset.
When required, stop the DR16pro, then set an offset. See "Setting a Relative Time Offset" on page
83.
Note: If the timecode signal is interrupted during SMPTE-LTC slave synchronization, the
DR16pro will stop playback until the signal is again received.
Sync Mode
key.
Page 119
Display
S M P T E - L T C
M I D I - S P P
M I D I - M T C
M I D I - M M C
Display
S M P T E 2 4 F
E B U 2 5 F
S M P T E 3 0 F
S M P T E 3 0 D
S M P T E 2 9 . 9 7
S M P T E 2 9 . 9 7 D
14: Synchronization