Akai DR16 pro Operator's Manual page 126

9) Press the STORE/ENT key.
The new connector will be selected.
10) If everything is set correctly, press the STORE/ENT key.
The DR16pro will display the message "S TA RT TAPE".
11) Start playback on the DAT recorder.
When the DR16pro receives the data, it starts loading data and the display shows the mes-
sage "BUSY". The message changes momentarily to "D ON E" when the operation is com-
plete, then the DR16pro returns to normal mode.
To load from multiple tapes:
If the data has been backed up on multiple tapes, the DR16pro will display "N E XT TAPE" when
the loading of data from the first tape is complete.
12) Replace the tape and resume playback on the DAT.
The DR16pro automatically resumes the loading operation when it receives data from the
tape. The display shows the message "BUSY". The message changes momentarily to "DONE"
when the operation is complete, then the DR16pro returns to normal mode.
Note: To load data stored on multiple tapes, be sure to insert the DAT tapes in the same
sequence as during the backup operation.
Restore Notes
If at any time during the restore function you want to cancel this procedure, press the ESCAPE
key. The message "ABORT" will appear on the display. Press any key to continue.
Page 117
13: Backup and Restore