Perform Engine Maintenance - Perkins Models; Check The Turntable Rotation Bearing Bolts - Genie ZX-135/70 Service Manual

Service Manual
Checklist D Procedures
D-7
Perform Engine Maintenance –
Perkins Models
Engine specifications require that this procedure
be performed every 1000 hours.
• Engine valve lash – inspect/adjust
Required maintenance procedures and additional
engine information is available in the Perkins
1100D Operation and Maintenance Manual
(Perkins part number SEBU8172-00).
Perkins 1100D Operation and Maintenance Manual
Genie part number
72
D-8
Check the Turntable Rotation
Bearing Bolts
Genie specifications require that this procedure be
performed every 1000 hours or annually,
whichever comes first.
Maintaining proper torque on the turntable bearing
bolts is essential to safe machine operation.
Improper bolt torque could result in an unsafe
operating condition and component damage.
1 Raise the secondary boom to the point where
it begins to extend. Turn the machine off.
123702
2 Remove the engine pivot plate retaining
fastener. Swing the engine pivot plate out
away from the machine.
1 engine pivot plate anchor hole
2 engine pivot plate retaining fastener
3 Locate the engine pivot plate anchor hole at
the pivot end of the engine pivot plate.
ZX-135/70
August 2014
Part No. 218700