Genie ZX-135/70 Service Manual page 37

Service Manual
Maintenance Inspection Report
Model
Serial number
Date
Hour meter
Machine owner
Inspected by (print)
Inspector signature
Inspector title
Inspector company
Instructions
• Make copies of this report to use for
each inspection.
• Select the appropriate checklist(s) for
the type of inspection(s) to perform.
Daily or every 8 hours
Quarterly or every
250 hours
Semi-annually or
every 500 hours
Annually or A + B + C + D
every
1000 hours
Two-year or A + B + C + D + E
every
2000 hours
• Place a check in the appropriate box
after each inspection procedure is
completed.
• Use the step-by-step procedures in
this section to learn how to perform
these inspections.
• If any inspection receives an "N," tag
and remove the machine from service,
repair and re-inspect it. After repair,
place a check in the "R" box.
Legend
Y = yes, acceptable
N = no, remove from service
R = repaired
22
Checklist C
C-1 Engine maintenance -
Deutz models
C-2 Engine maintenance -
Deutz models
C-3 Engine maintenance -
Perkins models
C-4 Engine air filter
C-5 Grease platform
overload (if equipped)
C-6 Test platform
overload (if equipped)
C-7 Engine RPM
C-8 Turntable bearing
wear
Checklist D
D-1 Boom wear pads
D-2 Free-wheel
configuration
D-3 Drive hub Oil
D-4 Turntable rotation
A
gear backlash
A + B
D-5 Hydraulic filter
D-6 Engine maintenance -
A + B + C
Deutz models
D-7 Engine maintenance -
Perkins models
D-8 Turntable bearing
bolts
Y N R
Y N R
ZX-135/70
August 2014
Checklist E
E-1 Hydraulic oil
E-2 Engine maintenance -
Perkins models
E-3 Engine maintenance -
Deutz models
Perform every 3000 hours:
E-4 Engine maintenance -
Perkins models
E-5 Engine maintenance -
Perkins models
E-6 Engine maintenance -
Deutz models
Perform every 4000 hours:
E-7 Engine maintenance -
Perkins models
Perform every 5000 hours:
E-8 Engine maintenance -
Deutz models
Comments
Part No. 218700
Y N R