Genie ZX-135/70 Service Manual page 142

August 2014
20 Remove the mounting fasteners that attach
the lower cable track to the primary boom lift
cylinder.
21 Remove the mounting fasteners that attach
the cable track to the primary boom.
22 Carefully remove the cable track from the
machine and lay it on a structure capable of
supporting it.
Crushing hazard. The primary
boom cable track could become
unbalanced and fall when
removed from the primary boom
if not properly supported by the
overhead crane.
Component damage hazard.
The boom cable track can be
damaged if it is twisted.
Component damage hazard.
Cables and hoses can be
damaged if they are kinked or
pinched.
Part No. 218700
How to Repair the Primary Boom
Cable Track
Note: A cable track repair kit is available through
the Genie Service Parts Department.
1 Visually inspect the cable track and determine
which 4-link section needs to be replaced.
2 Support the cable track assembly above the
section to be replaced.
3 Carefully remove the snap rings and pins from
each end of the damaged section of cable
track.
4 Remove the retaining fasteners from the
upper black rollers from the 4-link section of
cable track to be replaced. Remove the
rollers.
5 Lift up the hoses and cables and carefully
remove the damaged 4-link section of cable
track.
ZX-135/70
Service Manual
Boom Components
Component damage hazard.
The boom cable track can be
damaged if it is twisted.
Component damage hazard.
Cables and hoses can be
damaged if they are kinked or
pinched.
127