Genie ZX-135/70 Service Manual page 165

Service Manual
Ground Controls
3 Turn the service bypass/recovery key switch
to the service bypass position.
4 Using auxiliary power, operate the platform
level toggle switch to level the platform.
Note: Only the auxiliary power unit can be used to
correct an out of level platform fault.
5 Turn the service bypass/recovery key switch
to the run position.
6 Remove the key from the service
bypass/recovery key switch and insert the key
into the main key switch.
Note: If the Service Bypass function has been
used, there may be faults with the machine. Check
the LCD screen on the ground control box for
machine faults, then contact trained service
personnel.
150
How to Use the Recovery Mode
Recovery is only to be used as a last attempt to
lower the platform when the operator in the
platform is unable to do so, system failure or in
emergency situations.
The Recovery mode allows the platform to be
lowered in the event the operator in the platform is
unable to lower the platform using the platform
controls, system failure or emergency situations.
The recovery sequence will automatically retract
the primary boom and then lower the primary
boom using the auxiliary power unit to allow the
operator at the platform controls to exit the
platform.
1 Turn the main key switch to the off position.
Remove the key from the main key switch and
insert the key into the service bypass/recovery
key switch.
ZX-135/70
August 2014
Bodily injury hazard. When using
recovery mode, the platform may
not fully lower to the ground
when the recovery mode is
completed. Failure to use only
suitable equipment and/or
practices to allow the operator to
safely exit the platform could
result in death or serious injury.
Bodily injury hazard. Platform
leveling is not active when using
recovery mode. The platform
could reach high out-of-level
conditions when using this mode.
The operator will need to secure
themself to the platform to
prevent falling injury.
Part No. 218700