Table of Contents
Advertisement
highlight Location and use tu to change the location. Possible settings are: East and West. Once all
settings are made press gREEn to save or EXIT to quit without saving.
Adding a satellite
To add a satellite, make sure the highlight is not in the transponders list (press t in case of doubt) and
press YElloW. The procedure for adding a satellite is the same as for editing a satellite.
7.2 setup
Use the Setup menu to configure the system settings of your receiver. The following sub-menus are
available: Language, Output Options, Time Setting, Parental Control and OSD Display. Choose the desired
submenu with pq and press ok to advance.
7.2.1 language
Here you can set the preferred Display, Audio and Subtitle languages and Country setting. Use pq to
highlight the setting you wish to change and tu to change the value of the highlighted setting. Press
ok for a list with all available options for the chosen setting.
Display:
Audio:
Subtitle:
Country:
Once all settings are made, press EXIT to leave the Language menu. A confirmation banner will be
shown. Press ok to save your settings or EXIT to discard.
7.2.2 output options
This is the menu to configure the audio and video outputs of your receiver. Use pq to highlight the
setting you wish to change and tu to change the value of the highlighted setting. Press ok for a list
with all available options for the chosen setting.
TV Standard:
Aspect Ratio:
Conversion mode:
SCART Mode:
Digital Audio:
12
This setting affects the menu language of your receiver. All menu's and
messages will be displayed in this language.
is the preferred audio language. The receiver will automatically switch audio to
the preferred language whenever available.
Whenever available, subtitles will be displayed in the selected language.
Here you can set your country of residence.
Set the standard corresponding to your TV set. Available options are: Auto,
NTSC, PAL and SECAM.
Use this option to set the aspect ratio of your TV set. Available options are: 4:3
and 16:9.
Use this option to set the preferred way of converting 16:9 broadcasts to 4:3 TV
format. You can choose between the following options: Letter-box (the full 16:9
picture will be displayed on your 4:3 TV set with black bars above and below the
picture.), Pan and scan (The centre of the 16:9 picture will be displayed full-screen
on your 4:3 TV) and Combined (Combination of Letter-box and Pan and scan.)
Select RGB for the best picture quality or CVBS in case your TV doesn't support RGB.
Defines the format available on the S/PDIF output of your receiver. When set
to PCM, the digital output will always output PCM stereo regardless of the
broadcasted audio format. The Auto setting will pass all incoming digital audio
through the digital output. Use this option if you have your receiver connected
PART 1 • English
Advertisement
Table of Contents
