System Setup - Strong SRT 3002 User Manual

7.2.2 Auto Scan
Use p/q to select Installation and press OK or u to advance.
Select Auto Scan with p/q and press OK to enter.
Select your country and network.
Use p/q to highlight Search. Now press OK to start auto scan.
The receiver will store all found channels in the channel list.
NOTE: Network ID (NID) and other technical data can be found on the website of your "Provider"
(Broadcaster, cable network/your local cable system) usually. Start a Network search from
there to find all channels belonging to the network.
7.2.3 Network ID scan
Select Network ID scan and press OK to enter the Network ID scan menu. Press pq t u to set Frequency, Symbol Rate,
Scan QAM and Network ID. Obtain technical data about your cable provider's base channel and Network ID from your
provider and start a Network ID scan from there to find all channels belonging to the network corresponding to the
Network ID. Highlight Search and press OK to start the search. Network ID (NID) and other technical data can be found
on the website of your "Provider" (Broadcaster, cable network/your local cable system) usually. Start a Network search
from there to find all channels belonging to the network.
7.2.4 LCN (Logical Channel Numbering)
If LCN (Logical Channel Numbering) is activated and an LCN signal is provided by the provider, channels will be stored
in a provider defined order. Set LCN to On to activate provider defined channel numbering or Off to store channels in
found order. This function only applies when a new channel search is performed.
7.2.5 Free/All channels.
If Free is selected, only "Free-to-air" channels are stored.
If [All} is selected, scrambled channels will also be stored.
NOTE:
Only Free channels can be watched with this unit.

7.3 System Setup

This menu allows you to manage the system settings of your receiver. It consists of the following sub-menus: Language,
TV System, Local Time Setting, Timer Setting, Parental Lock, OSD Setting, Audio Description Setting and Auto Standby.
Press p/q to highlight the menu of choice and press OK advance to the next screen. Use p/q to move the highlight
to the setting of choice. Values can be changed with tu. Press  to leave.
7.3.1 Language
This menu allows you to set up your language preferences.
Use tu to select the language for the On Screen Display.
Language:
Use tu to select Audio language.
First Audio:
Use tu to select a language that will be played when the language selected at First Audio isn't
Second Audio:
available.
Use tu to select the use of subtitle Normal, Hard of Hearing or Off.
Subtitle Display:
Use tu to select the preferred subtitle language.
Subtitle Language :
2nd Subtitle Language: Use tu to select the preferred 2nd subtitle language if the 1st preference is not available.
Use tu to select the preferred Teletext language (when available).
Teletext:
*Availability of DVB/Hard of Hearing subtitles depends on the broadcast. If subtitles are not supported, they might be activated via Teletext if
available.
13