Table of Contents
Advertisement
note:
7.0 mAIn mEnU
All important settings and features of your receiver can be operated from the Main Menu. It consists
of the following sub-menus: Installation, Setup, Channel, Advanced and Games. Use tu to select a
sub-menu and pq to choose an option. Press ok to advance to the chosen submenu. Press mEnU in
viewing mode to display the Main Menu.
7.1 Installation
The installation menu allows you to change satellite settings and to search for channels. It consists of the
following sub-menus: Satellite Settings, Auto Scan, Manual Scan and Satellite Edit. Choose the desired sub
menu with pq and press ok to advance.
7.1.1 satellite settings
Use this menu to change the settings for a given satellite and to configure the parameters for the used
antenna Use pq to highlight Satellite and tu to set the satellite you wish to change the settings for.
To see a list with all available satellites, press ok when the highlight is on Satellite. Use pq to highlight
Transponder and tu to set the desired transponder. Signal bars indicating signal quality and strength
can be found on the bottom of the screen. These bars show the signal conditions for the chosen satellite
and transponder. You can now adjust the following settings: LNB type, LO Frequency, LNB power, Band
(22 kHz), Switch Type, Switch Input, Dish Mode and Dish Position. Once all settings are made, press EXIT
to get to the previous menu or use pq to highlight Go To and tu to select Auto Scan or Manual Scan
to advance to Auto Scan or Manual Scan.
A confirmation banner will now be displayed. Press ok to confirm the made changes or EXIT to discard.
7.1.2 Auto scan
Use this menu to perform an automatic channel search on one or more satellites.
On the left of the screen, a list with satellites is displayed. Use pq to highlight the satellite(s) you wish
to scan and press ok to mark the highlighted satellite. Press ok again to unmark a marked satellite.
note:
Now select the desired scanning options on the right of the screen. Use u pq to highlight and ok to
set an option.
Scan Mode All:
Free:
10
The Timeshift will only work correctly when a fast USB storage device such as
an USB2.0 HDD is connected to the receiver. Distorted picture and / or audio
during Timeshift indicate a low USB device speed. STRONG cannot guarantee
for USB devices used. Especially when Timeshift is activated at channels with
high data rate (High quality SD/HD), STRONG cannot guarantee an accurate
Playback of the Timeshift file.
you can mark multiple satellites. Auto Scan will search all marked satellites for
available channels.
scan all channels
scan Free-To-Air channels only
PART 1 • English
Advertisement
Table of Contents
